| |
|
|
 |
|
AAC Introduction
| What is the AAC Panel? |
AAC production Process |
Application Scope |
After Sale Service |
Features of the AAC Panels and Blocks |
- Raw material Preparation
Mix silica sand, cement, calcium lime, and gypsum, and then add a little aluminum powder to the slurry.
- Steel bar Assembling
Assemble the anti-rust treated steel bars into mesh frames, then put them into the moulds, and pour the material slurry
- Foaming
Chemical reactions begin after the pouring of the slurry. Bubbles appear evenly in the mould structure. The bubbles emerging at the time will determine the performance of AAC panels.
- Cutting
After the structure gains its early strength foaming and waiting, cut with piano wires and get the needed length, width, and thickness of the panels.
- Autoclave Treatment
Use autoclaves to treat AAC panels and make them hardened in high-temperature and high-pressure steams.
- Post-Processing
Decorative patterns will be made on the surfaces of the autoclaved panels that have been treated in autoclaves, according to the customer's requirements.
- Quality Inspection
All panels will undergo strict quality inspection in order that their good quality is ensured.
- Delivery
Only products strictly inspected can be delivered.
 |
|
|
|
